Hayes synchronizer brake controller manual






















The display on the Hayes Syncronizer Trailer Brake Controller # HA should illuminate both when you press the brake pedal and when you use the manual override lever. If it does not light up when you press the brake pedal then either there is a problem wit the red wire's connection to the brake light circuit or you have the power set so low that the display does not /5(34). SYNCRONIZER® Electronic Brake Controller Hayes Brake Controller Company P/N INSTALLATION MANUAL For trailers with electric brakes and vehicles with 12 volt negative ground systems only. READ AND SAVE THESE INSTRUCTIONS • Before beginning installation, read and become familiar with these instructions. At Hayes Towing Electronics, our Syncronizer trailer brake controller is great for single and tandem axle trailers equipped with electric brakes. This system provides real-time brake controller wiring modulation of electrical current from .


The Syncronizer is a brake controller for single and tandem axle trailers equipped with electric brakes. It modulates and controls the current from the battery to the trailer brakes. The longer the brake pedal is depressed the greater the current delivered to the trailer brakes until the preset brake power setting is reached. The Hayes Syncronizer Trailer Brake Controller - 1 to 2 Axles - Time Delayed # HA should not give off any smell and should not be activating the brakes enough to cause smell if installed and adjusted properly. I've attached a video of this installation for you to reference. When installed correctly, this unit should be adjusted for sensivity. Hayes® - Syncronizer Time Delayed Brake Control Featured View Hayes® - Syncronizer Time Delayed Brake Control Manual Made In USA Hayes Authorized Dealer $ In Stock (25) - Ships Tomorrow


Click for more info and reviews of this Hayes Trailer Brake Controller:www.doorway.ru out some si. SYNCRONIZER® Electronic Brake Controller Hayes Brake Controller Company P/N INSTALLATION MANUAL For trailers with electric brakes and vehicles with 12 volt negative ground systems only. READ AND SAVE THESE INSTRUCTIONS • Before beginning installation, read and become familiar with these instructions. The first Hayes trailer brake controller was invented by The Kelsey Hayes Company in Detroit Michigan in the ’s. These original trailer brake controllers were hydraulic over electric and required a direct tie in to the tow vehicle’s air or hydraulic braking system. In the ’s the technology moved to the proportional electronic.

0コメント

  • 1000 / 1000